Search results for 'HEATER BLOCK'
-
$9.80.25mm JET RSB Nozzle. Compatible with e3d v6 nozzles designed for 3mm filament. Learn More -
$55.00EXPERTS ONLY - 0.10mm JET RSB Nozzle. Compatible with e3d v6 nozzles designed for 3mm filament although this will work with 1.75mm filament also. Learn More -
$18.90Insulator - for Ultimaker2 - goes between white teflon isolator and heater block (Olsson or Ultimaker). Learn More -
$40.00Wow - heated bed conversion kit for UM2GO! Includes everything you need: Peel-and-stick heater with temp sensor, firmware. Instructions and more details are here.This is version 2 of the kit which is cheaper, easier to install (version 1 required installing a new nozzle heater) and it smells better (I found the silicone version was a little stinky when printing ABS - although the ABS also smells bad). Learn More
-
$29.00EXPERTS ONLY - 0.15mm JET RSB Nozzle. Compatible with e3d v6 nozzles designed for 3mm filament. Learn More -
$48.00EXPERTS ONLY - 0.15mm nozzle - this is a very easy nozzle to clog and very slow but it can make amazing detail. Just stunning.
Compatible with Olsson block, block v3, printrbot UBIS 13S, Raise 3D, or printers compatible with e3dv6 nozzles.
Works with UMO if you modify or remove fan shroud.
Learn More -
$9.80 As low as: $9.00Click here for ICE version.4mm JET RSB Nozzle. Compatible with e3d v6 nozzles designed for 3mm filament. Learn More
-
$18.90Convert to 1.75mm! This is experimental. I haven't tried it - I don't know if anyone has. I'm not sure if changing this part alone is enough - it seems like it should be as on the UM2 you only have to change the heating block and the teflon part - certainly you don't need to change the bowden. So I think it will work.Replaces Ultimaker Original (not Ultimaker2) teflon part but this part can print at 255C continuous for years. Never replace your teflon part again. This is made of teflon but it's a high temperature teflon. Learn More
-
$9.80.8mm JET RSB Nozzle. Compatible with e3d v6 nozzles designed for 3mm filament. Learn More -
Starting at: $9.80
It's not the one from Ultimaker. This is my version of their upgrade kit. Much less expensive - please read description below.Set qty to zero for what you already have or don't want and then "add to cart".
PLEASE READ FULL DESCRIPTION BELOW. Learn More