Search results for 'steel nozzle'
-
$9.80.25mm JET RSB Nozzle. Compatible with e3d v6 nozzles designed for 3mm filament. Learn More -
$223.00100% 3DSolex parts. Compatible with Ultimaker 3, S3 and S5 PrintersYou get a complete core already upgraded to include the 3DSolex hardcore heater block which lets you change nozzles. Included nozzles:
- .25mm
- .40mm (race)
- .60mm (race)
- .80mm (race)
-
$40.00Wow - heated bed conversion kit for UM2GO! Includes everything you need: Peel-and-stick heater with temp sensor, firmware. Instructions and more details are here.This is version 2 of the kit which is cheaper, easier to install (version 1 required installing a new nozzle heater) and it smells better (I found the silicone version was a little stinky when printing ABS - although the ABS also smells bad). Learn More
-
$275.00Print core for UM S5, S3 and UM3 with REPLACEABLE NOZZLES!
Learn More
Kit ships with 1 x .60mm and 1 x .80mm Ruby nozzles.
Other sizes available! -
$18.90Insulator - for Ultimaker2 - goes between white teflon isolator and heater block (Olsson or Ultimaker). Learn More -
$65.00Super hard nozzle. Made from ruby or sapphire. Sapphire and ruby are one level softer on the hardness scale from Diamond. Print many spools of CF filament with no wear.These work on UM2, UM2+ and will work on UMO if you change or remove the fan shroud and readjust Z home position.
Also compatible with Raise3D, Printrbot, Lulzbot. These are e3dv6 style compatible nozzles. Learn More
-
$9.801mm nozzle for really fast prints. If you plan to do .5mm layer height it's recommended to also get a 35W or 40W heater.These nozzles are e3dv6 compatible meaning they work with all versions of the Olsson block including the one on the Ultimaker 2+. They work on other reprap printers also.
The JET RSB have a revised tip angle, revised jet shoulder width and revised internal geometry, with a gentle slope leading down to the exit. They are also slippery inside, due to a special treatment.
These new nozzles are meant for Speed! Plastic will flow more easily than in most other nozzles. Atomic pulls work very well! The inside geometry makes it much harder for plastic to “hide in the corners”, so changing color/filament type will be quicker and safer.
For "3mm" filament (not 1.75mm filament). Learn More
-
$15.00ALL BATH INTERFEROMETER PRODUCTS HAVE BEEN MOVED TO MY NEW STORE HERE:
https://thegr5store.com/wp/The plastic parts you need to build a nice XYZ stage for an interferometer or Foucault test.
Missing:
2 feet of 1/4 inch stainless steel rod
1 foot of brass tubing to go around that
1 foot of 8-32 threaded rod
3 8-32 nuts
6 8-32 lock nuts
Interferometer Learn More -
$65.00Super hard nozzle. Made from ruby or sapphire. Sapphire and ruby are one level softer on the hardness scale from Diamond. Print many spools of CF filament with no wear.You must have the 3DSolex Hardcore to use this nozzle.
These work on UM3, S3 and S5 only. Learn More
-
$12.20 As low as: $12.000.5mm Steel nozzle! Meant for printing abrasive materials. Learn More