Search results for '3Dsolex heated bed'
-
$16.50
Replaces Ultimaker2 teflon part. This is made of PTFE but it's a high temperature teflon. First there was regular PTFE (both Ultimaker and 3dsolex). Then there was "TFT" (3dsolex and soon after Ultimaker). Now there is "TFN". TFN lasts about the same amount of time as TFT depending on temperature. Learn More
-
$12.20 As low as: $12.000.5mm Steel nozzle! Meant for printing abrasive materials. Learn More
-
$223.00100% 3DSolex parts. Compatible with Ultimaker 3, S3 and S5 Printers
You get a complete core already upgraded to include the 3DSolex hardcore heater block which lets you change nozzles. Included nozzles:
- .25mm
- .40mm (race)
- .60mm (race)
- .80mm (race)
-
$65.00Super hard nozzle. Made from ruby or sapphire. Sapphire and ruby are one level softer on the hardness scale from Diamond. Print many spools of CF filament with no wear.
You must have the 3DSolex Hardcore to use this nozzle.
These work on UM3, S3 and S5 only. Learn More
-
Starting at: $9.80
It's not the one from Ultimaker. This is my version of their upgrade kit. Much less expensive - please read description below.Set qty to zero for what you already have or don't want and then "add to cart".
PLEASE READ FULL DESCRIPTION BELOW. Learn More
-
$40.00Wow - heated bed conversion kit for UM2GO! Includes everything you need: Peel-and-stick heater with temp sensor, firmware. Instructions and more details are here.
This is version 2 of the kit which is cheaper, easier to install (version 1 required installing a new nozzle heater) and it smells better (I found the silicone version was a little stinky when printing ABS - although the ABS also smells bad). Learn More
-
$68.00
For Prusa I3 Mk3.
3DSolex is out of silicone socks so if you don't have any there are plenty of other ways to get those.
This sensational kit for the Prusa I3 Mk3 will transform your printer.
Safely change nozzle using our tools included in kit.
Ramp up plastic output thanks to our patented core heating nozzles and fully utilizing the Bondtech feeder already installed in your printer. By combining nozzle size, layer height and speed you can achieve up to 30 cubics / second.
Learn More -
$285.00100% 3DSolex parts. Compatible with Ultimaker 3, S3 and S5 Printers
You get a complete core already upgraded to include the 3DSolex hardcore heater block which lets you change nozzles. Included nozzles:
- .25mm
- .40mm (race) X 2
- .50mm steel
- .60mm (race)
- .80mm (race)
- 1.0mm (race)
-
$65.00Super hard nozzle. Made from ruby or sapphire. Sapphire and ruby are one level softer on the hardness scale from Diamond. Print many spools of CF filament with no wear.
You must have the 3DSolex Hardcore to use this nozzle.
These work on UM3, S3 and S5 only. Learn More