Search results for 'JET Set 4 (Set of 4 JET RSB Nozzles)'

.25mm JET RSB Nozzle. Compatible with e3d v6 nozzles designed for 3mm filament. Learn More

Super hard nozzle. Made from ruby or sapphire. Sapphire and ruby are one level softer on the hardness scale from Diamond. Print many spools of CF filament with no wear.

You must have the 3DSolex Hardcore to use this nozzle.

These work on UM3, S3 and S5 only. Learn More

Learn More

Replaces Ultimaker2 teflon part. This is made of PTFE but it's a high temperature teflon. First there was regular PTFE (both Ultimaker and 3dsolex). Then there was "TFT" (3dsolex and soon after Ultimaker). Now there is "TFN". TFN lasts about the same amount of time as TFT depending on temperature. Learn More

These will work with any Ultimaker printer and many other printers with 6mm wide GT2 belts but these are meant for the Ultimaker Original. Pack of 5. See this video for instructions both on testing your belt tension and installing these tensioners:

 

https://youtu.be/SGtjjeDugUA

Learn More

Insulator - for Ultimaker2 - goes between white teflon isolator and heater block (Olsson or Ultimaker). Learn More

Super hard nozzle. Made from ruby or sapphire. Sapphire and ruby are one level softer on the hardness scale from Diamond. Print many spools of CF filament with no wear.

These work on UM2, UM2+ and will work on UMO if you change or remove the fan shroud and readjust Z home position.

Also compatible with Raise3D, Printrbot, Lulzbot. These are e3dv6 style compatible nozzles. Learn More

For Prusa I3 Mk3.

3DSolex is out of silicone socks so if you don't have any there are plenty of other ways to get those.

This sensational kit for the Prusa I3 Mk3 will transform your printer.

Safely change nozzle using our tools included in kit.

Ramp up plastic output thanks to our patented core heating nozzles and fully utilizing the Bondtech feeder already installed in your printer. By combining nozzle size, layer height and speed you can achieve up to 30 cubics / second.

Learn More

1mm nozzle for really fast prints. If you plan to do .5mm layer height it's recommended to also get a 35W or 40W heater.

These nozzles are e3dv6 compatible meaning they work with all versions of the Olsson block including the one on the Ultimaker 2+. They work on other reprap printers also.

The JET RSB have a revised tip angle, revised jet shoulder width and revised internal geometry, with a gentle slope leading down to the exit. They are also slippery inside, due to a special treatment.

These new nozzles are meant for Speed! Plastic will flow more easily than in most other nozzles. Atomic pulls work very well! The inside geometry makes it much harder for plastic to “hide in the corners”, so changing color/filament type will be quicker and safer.

For "3mm" filament (not 1.75mm filament). Learn More