This converts a regular UM2, UM2go, UM2ext to be like the UM2 plus feeder where you get 2X the power due to a 2:1 gear reduction. More details below. Does not include printed parts. Learn More

100% 3DSolex parts. Compatible with Ultimaker 3, S3 and S5 Printers

You get a complete core already upgraded to include the 3DSolex hardcore heater block which lets you change nozzles. Included nozzles:

• .25mm
• .40mm (race)
• .60mm (race)
• .80mm (race)

Learn More

Wow - heated bed conversion kit for UM2GO! Includes everything you need: Peel-and-stick heater with temp sensor, firmware. Instructions and more details are here.

This is version 2 of the kit which is cheaper, easier to install (version 1 required installing a new nozzle heater) and it smells better (I found the silicone version was a little stinky when printing ABS - although the ABS also smells bad). Learn More

ALL BATH INTERFEROMETER PRODUCTS HAVE BEEN MOVED TO MY NEW STORE HERE:

https://thegr5store.com/wp/Learn More

ALL BATH INTERFEROMETER PRODUCTS HAVE BEEN MOVED TO MY NEW STORE HERE:

https://thegr5store.com/wp/Every laser comes with a calibration card telling you the wavelength (every laser is a little different - usually 650 to 660nm). Every laser runs on normal USB power (5v) which comes from phone chargers, USB cigarette adapters, USB batteries, computers, laptops, etc. Comes with 1 meter long power cord. You must supply your own USB power source.

This laser has 2 advantages over the cheaper laser I sell: larger beam and glass lens.

The glass lens means it is easy to clean without scratching. The other laser I sell has a plastic lens secured with a spring and the spring scratches the lens more and more every time you take it apart. This laser doesn't have any spring touching the lens.

More info below in description!

Learn More

100% 3DSolex parts. Compatible with Ultimaker 3, S3 and S5 Printers

You get a complete core already upgraded to include the 3DSolex hardcore heater block which lets you change nozzles. Included nozzles:

• .25mm
• .40mm (race) X 2
• .50mm steel
• .60mm (race)
• .80mm (race)
• 1.0mm (race)

Learn More

1mm nozzle for really fast prints. If you plan to do .5mm layer height it's recommended to also get a 35W or 40W heater.

These nozzles are e3dv6 compatible meaning they work with all versions of the Olsson block including the one on the Ultimaker 2+. They work on other reprap printers also.

The JET RSB have a revised tip angle, revised jet shoulder width and revised internal geometry, with a gentle slope leading down to the exit. They are also slippery inside, due to a special treatment.

These new nozzles are meant for Speed! Plastic will flow more easily than in most other nozzles. Atomic pulls work very well! The inside geometry makes it much harder for plastic to “hide in the corners”, so changing color/filament type will be quicker and safer.

For "3mm" filament (not 1.75mm filament). Learn More

ALL BATH INTERFEROMETER PRODUCTS HAVE BEEN MOVED TO MY NEW STORE HERE:

https://thegr5store.com/wp/Learn More

ALL BATH INTERFEROMETER PRODUCTS HAVE BEEN MOVED TO MY NEW STORE HERE:

https://thegr5store.com/wp/Learn More